Relocating mature trees

<h3>Replanting / Relocating mature trees</h3>

 

In our every day tree surgery we have to move trees as a requirement. It is a tricky process where success leads to a happy tree and if you don’t get it right… a dead tree. So, we decided to share some insights.  Japanese Acer tree planing

You should get ready for relocation procedure beforehand. Dig a groove with depth of 40-50 cm. around the tree intended for replanting a year or two beforehand. All the roots except small ones should be cut off by the inner wall. The groove should be filled with wet soil and then compacted. By the time the tree is ready to be taken out, there will be fibrils formed at the cutoff points of roots. While taking plants up You should be extremely careful not to damage the root fibrils as it is very important for the trees survival. The rootball should be encased firmly with hessian canvas and for added support it should be wrapped with wire cloth for the whole construction not to disperse while it’ll be transported. You can make additional casing with boards.

Removing the tree with a digger

Move and  place the tree carefully in a pit dug  up in advance at the chosen location that you prefilled with compost and feed. You should proceed to carefully remove all the packing materials: boards, wire cloth and hessian canvas. Center the tree and feel up the remaining space with the previously removed soil aiming to have the root collar of the tree placed at ground level. Trees usually suffer very painfully from both: too much deepening or being overexposed on soil level.

After planting the plant you should make a groove in the soil around it and fill it with water. After the water is soaked up – water it again. After watering the soil, cover it with woodchip so that the water does not to evaporate too quickly.

Replanted trees have a large canopy sail but the roots are still loosely bound to the ground. A strong wind may uproot them and to avoid this, immediately after planting You should strengthen the plants with stakes or anchor wires. It would be much safer and durable to set 3 anchor wires. Divide the circle space around the tree into 3 equal parts (about 120° each). Drive firm wooden stakes or metal studs into these points. At the place on the tree, where, in your opinion should the center of gravity of the trunk be, attach three anchor wires. Tighten them and strengthen the lower ends at the stakes or studs. Do not forget to enclose some cloth under the wires on the trunk otherwise the bark, cambium can get damaged as well as the entire tree can get damaged from choking by simply growing and gaining girth.Relocated tree

Trimming just replanted trees is not necessary. The more leaves will be on them the faster roots will recover. It would be good to get an automatic watering system set up for trees regular irrigation at that stage. They need a lot of water whilst the root system gains strength.

2014-10-07_14-45-23_717

 

 

You can contact our tree surgeons should you have any further or other queries.